Agrivoltaics keeps agriculture as the main use of the land and adds photovoltaic generation. Partial shade reduces the radiation available to the crop, so yield may fall in most crops, but in hot and dry climates it can bring benefits. The result depends on module density, height and crop, and must be measured against a reference plot.
Definition
Agrivoltaics intentionally combines crop or livestock production and photovoltaic generation on the same area. It differs from a conventional solar plant because agricultural activity must remain the primary use. Weselek et al. (2019) call for a clear separation of these systems from installations that only generate energy, by keeping sufficient crop productivity.
The concept was proposed in 1982 by Goetzberger and Zastrow, who suggested raising the collectors to about 2 m and increasing the spacing between them to avoid excessive shading of crops.
How it works
The modules intercept part of the light. According to the review by Weselek et al. (2019), radiation under the panels is reduced by about one third, although it varies with density, orientation and time of day. That shade changes the microclimate: it can reduce evaporation and alter rain distribution, which falls less uniformly under the system.
In an arid region, Barron-Gafford et al. (2019) measured less drought stress in plants under panels, and Hassanpour Adeh et al. (2018) measured higher soil moisture in an unirrigated pasture. Marrou et al. (2013a) observed that the effect on soil water depends on the crop species.
Main configurations
In the elevated configuration, the structure leaves a clear height for machinery to pass. Weselek et al. (2019) indicate that cereals with large combine harvesters need at least 4 to 5 m. In the between-row or near-ground configuration, the crop or pasture sits between the rows of modules.
The DIN SPEC 91434 standard (2021) defines two categories: category I, with an elevated structure and a minimum clear height of 2.10 m, and category II, with a structure close to the ground. Tracking systems allow shade to be adjusted during the day; Valle et al. (2017) reported that a controlled tracking mode increased crop biomass, at the cost of lower electricity production.
What the evidence shows
Dupraz et al. (2011) modeled, using the land equivalent ratio, total productivity gains of 35 to 73%. Weselek et al. (2019) summarize that land productivity can rise by up to about 70%, that the yield of most crops will probably fall because light decreases, and that in arid climates benefits from shade and better water productivity are likely.
Leafy vegetables and forages are among the crops with the best chance of keeping their yield under moderate shade. In a lettuce trial, Marrou et al. (2013b) obtained between 81 and 99% of the full-sun control yield, depending on variety, with 73% of the incident radiation available.
What is missing and how we approach it
Weselek et al. (2019) stress that only a few crops have been studied and that comparable field data are missing. Most of the results cited come from other climates, so they should not be transferred as they are to a specific property.
That is why AgroWatts approaches each project with a reference plot and with measurable crop and energy indicators. The Agrivoltaics and SDGs page explains what could be measured, and the article on the land equivalent ratio explains how to compare the result.
This article is informative. It is not agronomic or tax advice or a quote, and results depend on each site.
References
- Goetzberger A., Zastrow A. (1982). On the coexistence of solar-energy conversion and plant cultivation. International Journal of Solar Energy, 1: 55-69. doi:10.1080/01425918208909875
- Dupraz C., Marrou H., Talbot G., Dufour L., Nogier A., Ferard Y. (2011). Combining solar photovoltaic panels and food crops for optimising land use: Towards new agrivoltaic schemes. Renewable Energy, 36(10): 2725-2732. doi:10.1016/j.renene.2011.03.005
- Marrou H., Dufour L., Wery J. (2013a). How does a shelter of solar panels influence water flows in a soil-crop system?. European Journal of Agronomy, 50: 38-51. doi:10.1016/j.eja.2013.05.004
- Marrou H., Wery J., Dufour L., Dupraz C. (2013b). Productivity and radiation use efficiency of lettuces grown in the partial shade of photovoltaic panels. European Journal of Agronomy, 44: 54-66. doi:10.1016/j.eja.2012.08.003
- Weselek A., Ehmann A., Zikeli S., Lewandowski I., Schindele S., Högy P. (2019). Agrophotovoltaic systems: applications, challenges, and opportunities. A review. Agronomy for Sustainable Development, 39: 35. doi:10.1007/s13593-019-0581-3
- Hassanpour Adeh E., Selker J.S., Higgins C.W. (2018). Remarkable agrivoltaic influence on soil moisture, micrometeorology and water-use efficiency. PLOS ONE, 13(11): e0203256. doi:10.1371/journal.pone.0203256
- Barron-Gafford G.A., Pavao-Zuckerman M.A., Minor R.L., Sutter L.F., Barnett-Moreno I., Blackett D.T., Thompson M., Dimond K., Gerlak A.K., Nabhan G.P., Macknick J.E. (2019). Agrivoltaics provide mutual benefits across the food-energy-water nexus in drylands. Nature Sustainability, 2: 848-855. doi:10.1038/s41893-019-0364-5
- Valle B., Simonneau T., Sourd F., Pechier P., Hamard P., Frisson T., Ryckewaert M., Christophe A. (2017). Increasing the total productivity of a land by combining mobile photovoltaic panels and food crops. Applied Energy, 206: 1495-1507. doi:10.1016/j.apenergy.2017.09.113
- DIN e.V. (2021). DIN SPEC 91434:2021-05. Agri-photovoltaic systems: requirements for primary agricultural use. Beuth Verlag. din.de