Each parameter shifts the balance between crop and energy. More height allows more machinery, lower density lets more light through, and orienting modules southeast or southwest evens out the light under the system, at a small energy cost according to one simulation. There is no universal design: it depends on the crop, the machinery and the site.
Clear height
Clear height must fit the machinery. Weselek et al. (2019) note that cereals with large combine harvesters need at least 4 to 5 m. At the Heggelbach research facility in Germany the modules are at 5 m; in the test facility of Dupraz et al. (2011) they are at 4 m, and in Japanese solar sharing systems, at about 3 m.
The DIN SPEC 91434 standard (2021) sets a minimum clear height of 2.10 m for category I, and requires the height to meet occupational safety rules. More height raises the cost of the structure, and that decision is assessed together with the electricity savings and the agricultural yield preserved.
Density and row spacing
Dupraz et al. (2011) tested two module densities: electricity production rose with density, but the optimal conditions for the crop were found with less dense modules (Marrou et al. 2013b). In the lettuce trial, with 3.2 m between rows, up to 73% of the incident radiation reached the plant.
At the Heggelbach facility, with rows 6.3 m apart, the photosynthetically active radiation available under the system is estimated at about 60% of that above it (Weselek et al. 2019). Pillars and structures also take up land: Weselek et al. (2019) cite at least 2% of the area, and the DIN SPEC 91434 standard (2021) allows an agricultural area loss of less than 10% in category I and less than 15% in category II.
Orientation and tilt
In a simulation for a German system, Beck et al. (2012) found that orienting the modules southwest or southeast gave more uniform light under the system, with a predicted 5% reduction in electricity production compared with south orientation. The optimal angle depends on latitude: in Central Europe it is around 20 to 25°, and must not be transferred to another site without calculating it.
A small angle favors dust accumulation, because rain washes it off less well, and in dry areas it may require occasional cleaning (Weselek et al. 2019).
Solar tracking
Trackers allow the position of the modules to change during the day. Valle et al. (2017) compared normal tracking and a controlled mode that reduces shade in the morning and afternoon and increases it at midday: the controlled mode increased crop biomass but reduced electricity production compared with normal tracking. Weselek et al. (2019) add that the light available under the system depends more on module density than on module mobility.
How we apply it and what we do not know
These values come from trials in Europe and are not recommendations for a Mexican property. At AgroWatts, height, spacing and orientation are defined after reviewing the site's crop, machinery, solar resource and interconnection, and are documented so they can be compared with a reference plot.
There are still not enough data for many crops and climates, and Weselek et al. (2019) call for more field trials with different species and conditions.
This article is informative. It is not agronomic or tax advice or a quote, and results depend on each site.
References
- Dupraz C., Marrou H., Talbot G., Dufour L., Nogier A., Ferard Y. (2011). Combining solar photovoltaic panels and food crops for optimising land use: Towards new agrivoltaic schemes. Renewable Energy, 36(10): 2725-2732. doi:10.1016/j.renene.2011.03.005
- Marrou H., Wery J., Dufour L., Dupraz C. (2013b). Productivity and radiation use efficiency of lettuces grown in the partial shade of photovoltaic panels. European Journal of Agronomy, 44: 54-66. doi:10.1016/j.eja.2012.08.003
- Weselek A., Ehmann A., Zikeli S., Lewandowski I., Schindele S., Högy P. (2019). Agrophotovoltaic systems: applications, challenges, and opportunities. A review. Agronomy for Sustainable Development, 39: 35. doi:10.1007/s13593-019-0581-3
- Beck M., Bopp G., Goetzberger A., Obergfell T., Reise C., Schindele S. (2012). Combining PV and food crops to agrophotovoltaic: optimization of orientation and harvest. 27th European Photovoltaic Solar Energy Conference and Exhibition, 4096-4100. doi:10.4229/27thEUPVSEC2012-5AV.2.25
- Valle B., Simonneau T., Sourd F., Pechier P., Hamard P., Frisson T., Ryckewaert M., Christophe A. (2017). Increasing the total productivity of a land by combining mobile photovoltaic panels and food crops. Applied Energy, 206: 1495-1507. doi:10.1016/j.apenergy.2017.09.113
- DIN e.V. (2021). DIN SPEC 91434:2021-05. Agri-photovoltaic systems: requirements for primary agricultural use. Beuth Verlag. din.de